MODEL: DIVER SE

MOVEMENT : SII NH36A optimized by MATIC^®

WATER RESISTANCE : 30bar / 300m

Characteristics of Mechanical watches

About time accuracy of mechanical watches

The time accuracy described in this instruction manual is the static accuracy at normal temperature. The accuracy of mechanical watches may get out of the described range depending on the following three usage conditions or other reasons.

• Winding amount of the mainspring
• Attitude
• Usage environment (temperature, magnetism, impact, etc.)

Requests and cautions regarding this watch

• Make sure to adequately wind the mainspring before setting the time (hour and minute hands).

• If the time is set without the mainspring being adequately wound, the second hand will oscillate back and forth 2-3 seconds. There are two ways to wind the mainspring: winding by turning the crown to the right by hand, and for the automatic winding watch, winding by shaking the watch gently.

Before using this watch

Protective Stickers

Be sure to remove any protective stickers that may be on your watch (case back, band, clasp, etc.). Otherwise, perspiration or moisture may enter the gaps between the protective stickers and the parts, which may result in a skin rash and/or corrosion of the metal parts.

How to use a specially designed crown

Unlock the crown prior to operating your watch.

Mainspring

Winding the mainspring manually

Unscrew the crown, slowly rotate the crown to the right (clockwise) using your thumb and index finger.

Winding the mainspring automatically

• When wearing the watch, your hand’s movement rotates the oscillating weight to wind the mainspring automatically.
The mainspring is wound for about a day movement automatically when wearing the watch for 8 hours or more a day.
• You can wind the mainspring manually.

Setting the time and calendar

Setting the time

1. Pull the crown out to position ‘2‘.
2. Rotate the crown to adjust the time.
   • Change of date indication shows it just became AM. Set the time to ensure proper AM or PM time is set.
   • Day changes a little later than the change of the date.
3. Push the crown into position ‘0‘ to finish the procedure.

Setting the day/date

1. Pull the crown out to position ‘1‘.
2. Rotate the crown to set the day and date.
3. Push the crown into position ‘0‘ to finish the procedure.

Water resistance

The unit “1bar” is roughly equal to 1 atmosphere.